Restore Device to Factory Settings¶

⚠️ Note: This document describes how to operate the scanning device using the SDK's API and provides sample code in C language. Please note that the API is a synchronous operation and may block the main thread during use.

⚠️ Note: Before using the API, you need to connect the device and register for message notifications to receive messages from the device. For detailed steps, please refer to Message Notification.

1. Restore Device to Factory Settings¶

To restore the scanning device to factory settings, use the following Bluetooth service and characteristic UUIDs to perform a write without response operation:

Bluetooth	UUID
Service	0x0000ff0000001000800000805f9b34fb
Characteristic	0x0000ff0400001000800000805f9b34fb

Use the following command to get the data to write to the characteristic:

const char* result = inateck_scanner_cmd_get_reset();

The return result is in JSON format. If the call is successful, result will return:

{
    "status": 0,
    "data": [0, 1, 2, 3],
}

If the call fails, result will return:

{
    "status": 1,
    "data": [],
}

2. Message Parsing¶

After waiting for the device to respond, you can use the following method to parse the data:

int result = inateck_scanner_cmd_check_result(data, data_length);

The return result is of type int. If the call is successful, result will return 0. If the call fails, result will return 1.

3. Sample Code¶

#include <stdio.h>
#include <string.h>
#include <stdbool.h>
#include <unistd.h>
#include "inateck_scanner_ble.h"

int main() {
    const char* result = inateck_scanner_cmd_get_reset();
    if (result) {
        // result is in JSON format, parse the data
        const unsigned char* data = (const unsigned char*)result;
        int data_length = strlen(result);

        // Send data via Bluetooth write without response
        // Assume there is a function send_data_via_bluetooth to send data
        send_data_via_bluetooth(data, data_length);

        // Wait for the device to respond, receive data
        // Assume there is a function receive_data_via_bluetooth to receive data
        receive_data_via_bluetooth();

        const unsigned char* data = get_received_data();
        int data_length = get_received_data_length();

        // Parse the data
        int result = inateck_scanner_cmd_check_result(data, data_length);
        if (result == 0) {
            printf("Reset success\n");
        } else {
            printf("Reset failed\n");
        }
    }
    return 0;
}